Track Judges Stand Installation Instructions

NOTE: All metal seats & footrest are inter-changeable.

Position frame approximately 43″ apart from the center of cross strap mounting holes.
Using (4) 3/8″ x 1 3/4″ bolts with nuts, fasten the two long cross straps to the vertical tubes at the rear of each frame. Insert (1) 3/8″ x 3/4″ bolt with nut through the center holes in the cross straps where they intersect each other (Do Not Tighten)
Using (4) 3/8″ x 1 3/4″ bolts with nuts, fasten the two short cross straps to the vertical tubes at the rear of each frame. Insert (1) 3/8″ x 3/4″ bolt with nut through holes in the cross straps where they intersect each other (Do Not Tighten).
Place metal seats and footrest on mounting surfaces.
Next, take each handrail and fasten each handrail with the mounting bracket between the 3rd and 5th metal seats starting from the bottom (No Not Tighten).
Using (4) 1/4″ x 3/4″ bolts with nuts, fasten the 1″ x 5″ x 48″ backrest plank to handrails (Do Not Tighten).
Fasten all remaining metal seats and footrest to the frame using 1/4″ x 3/4″ carriage bolts and nuts (Now Tighten All Fasteners). Your Track Judges Stand is now ready for use.

NOTE: A quantity of (4) 1/4″ flat washers may be included for the backrest
as needed.

SKU: 2600II